HomeProductsApplicationsServicesQualityAboutKnowledgeContact
Products / Solid-State Electrolytes

Solid-State Oxide Slurry

LATP oil-based slurry, D50 0.30 um

Oil-based LATP slurry for current-collector and electrode coating development.

Product Details

LATP slurry

Oil-based LATP slurry for current-collector and electrode coating development.

Category
Solid-State Oxide Slurry
Availability
RFQ

Typical Specification

  • Particle size: D50 0.30 +/- 0.05 um
  • Solid content: target +/- process range
  • Water: <= 500 ppm
  • pH: 8-12
Request QuoteBack to Solid-State Materials

Final values should be confirmed by grade, lot, COA/TDS, and intended processing conditions.

Technical Selection Guide

How should LATP oil-based slurry, D50 0.30 um be selected and tested?

LATP oil-based slurry, D50 0.30 um is a process-ready oxide-electrolyte dispersion for coating, separator-layer, and composite-electrolyte development. Slurry performance depends not only on LATP particle size but also on solids content, carrier compatibility, dispersion stability, rheology, drying, binder selection, and the final coated-layer density.

Why developers evaluate it

  • Coating and separator-layer process development
  • Composite cathode or polymer-ceramic studies
  • Pilot mixing, drying, and lamination trials

Development considerations

  • Confirm carrier and binder compatibility
  • Control sedimentation, viscosity, and coating uniformity
  • Measure conductivity after drying and densification

How to compare it

Compare slurry grades by coated-layer performance rather than liquid appearance alone. Relevant listed parameters include Particle size: D50 0.30 +/- 0.05 um; Solid content: target +/- process range; Water: <= 500 ppm. Confirm the final solids content and processing window for the intended coating method.

Solid-State Electrolytes Solid-State Materials Guide Compare Electrolyte Families Powder Screening Guide

Characterization

Tabular Data & Supporting Images

ParameterSpecification / ResultMethod
AppearanceWhite slurry, uniform colorVisual inspection
D50 particle size0.30 +/- 0.05 umLaser particle-size analyzer
Solid contentTarget value -0.5% to +1.5%; typical range 20-40%Solid-content test
Water<= 500 ppmKarl Fischer moisture analyzer
Viscosity<= 80 mPa.sViscometer
pH8-12pH meter
Magnetic impurities<= 500 ppbICP-OES
Use caseCurrent-collector or electrode coatingApplication guidance
LATP oil-based slurry, D50 0.30 um product image
Representative product image from the solid-state materials summary deck.